Full Product Manual

8
GENERATOR PREPARATION
The following section describes steps necessary to prepare the generator for use. If after reading this
section, you are unsure about how to perform any of the steps please call [phone] Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the generator or shorten its
lifespan.
Unpacking
Unpack the generator and all its parts, and compare against the list below. Do not discard the carton or
any packaging until the generator is completely assembled.
1
Wheel axle
8
Right handle bracket
2
Front foot
9
Bolt M8x38 (2)
3
Wheel (2)
10
Wheel cotter pin (2)
4
Screw (2) for front foot
11
Washer (4)
5
Handle
12
Nut M8 (4)
6
Left handle bracket
13
Spark plug wrench
7
Bolt M8x28 (2)
1 2 3
4
5
13
12
11
10
9
8 7 6