Full Product Manual

Step 2 - ADD OIL

The generator is shipped without oil. User must add the proper amount of oil before operating the

generator for the first time. The oil capacity of the engine crankcase is 20 fl. oz. For general use (above

40° F), we recommend 30W, 4-stroke engine oil.

ENGINE OIL RECOMMENDATIONS

Select good quality detergent oil bearing the American Petroleum Institute (API) service classifications

SJ, SL, or SM (synthetic oils may be used). Use the ASE viscosity grade of oil from the following chart

that matches the starting temperature anticipated before the next oil changes.

Engine Oil Temperature Recommendations

To add oil, follow these steps:

1. Make sure the generator is on a level surface. Tilting the generator to assist in filling will cause oil to

flow into engine areas and will cause damage. Keep generator level!

2. Remove the dipstick from the engine.

3. Add oil slowly. Do not overfill.

4. To check the oil level, wipe the dipstick with a clean rag. Insert the dipstick into the oil fill opening

without screwing it in. Remove the dipstick to check the oil mark.

5. Slowly add more oil and repeat step 4 until the oil mark reaches to the top of the dipstick. Do not

overfill the crankcase. The generator is equipped with a low-oil sensor and will not start if the amount of

oil is insufficient.

6. Check for oil leaks. Tighten dipstick firmly.

Oil Dipstick