Specification

10
BRUSH CUTTER PREPARATION
The following section describes steps necessary to prepare the brush cutter for use. If after reading this
section, you are unsure about how to perform any of the steps please call [phone] Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the brush cutter or shorten
its lifespan.
INSTALLING BRUSH CUTTER ATTACHMENT
CAUTION: When installing brush cutter attachment, place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the knob counterclockwise and lift the
locking lever.
2. Make sure the small hole on the attachment to match the slot on the
powerhead.
3. Push the attachment into the coupler.
6. Before using the unit, push down locking lever and tighten the knob
securely by turning clockwise.
WARNING: Make sure the locking/ release button is locked in the primary
hole and the knob is securely tightened before operating the unit. All
attachments are designed to be used in the primary hole unless otherwise
stated in the applicable attachment instruction manual. Using the wrong hole
could lead to serious injury or damage to the unit.
ATTACHING THE PLASTIC SHIELD
CAUTION: The shield must be properly installed. The shield provides
partial protection to the operator and others from the risk of thrown objects.
1. Attach the shield and bracket to the pipe of attachment.
2. Install hex screw using wrench and tighten securely.
ASSEMBLY OF SHOULDER STRAP
WARNING: Proper shoulder strap and handlebar adjustments must be made with the engine completely
stopped before using unit.
1. Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder.
Make sure the hook is to the right side of your waist.
NOTE: A one-half twist is built in the shoulder strap to allow the strap to rest flat on the shoulder.
2. Adjust the strap, allowing the hook to be about 6 inches (15 cm) below the waist.
3. Fasten the strap hook to the clamp located between the throttle trigger and the handlebar mounting
bracket and lift the tool to the operating position.
4. Try on shoulder strap and adjust for fit and balance before starting the engine or beginning a cutting
operation.
NOTE: It may be necessary to relocate the shoulder strap clamp on the shaft for proper balancing of unit.
Locking lever