Use and Care Manual

9
ASSEMBLY INSTRUCTION
Important: Prior to any assembly and adjustment always unplug the tool.
Changing the blade
Warning: Always disconnect the plug from the power mains before making any adjustment or attaching
any accessories.
 Place this circular saw on its side on a flat surface. Advice
you bring the base plate down as a minimum depth cut then
it is ease to change the blade.
 Push the spindle lock button (13) toward motor housing and
firmly hold it.
 Turn the blade clamp bolt (11) anti-clockwise by using the
hex key that supplied with the tool.
 Remove the blade clamp bolt (11) and outer flange (10).
 Raise the lower guard (12) by using the lever for lower
guard (1), and then remove the saw blade.
 Clean the saw blade flanges, then mount the new saw blade onto the output spindle.
 Make sure the saw teeth and arrow on the blade is to be the same direction as the arrow on the lower
guard.
 Reinstall the outer flange, and tighten the blade clamp bolt.
 Make sure that the saw blade runs freely by turning the blade by hand.
Depth adjustment
 Loosen the lock lever for depth adjustment (18).
 Hold the base plate flat against the edge of the work piece
and lift the body of the saw until the blade is at the right
depth determined by the depth of cut scale (17) (align the
scale line).
 Tighten the lock lever for depth adjustment.
Angle adjustment
 Loosen the Lock knob for angle adjustment (6).
 Adjust the shoe to the desired angle between 0°to 45°.
See miter scale (5).
 Tighten the lock knob for angle adjustment.