Use and Care Manual

10
Switching on and off
Before engage the ON/OFF switch, check that the saw
blade is properly fitted and run smoothly, the blade clamp
bolt is well tightened.
 Connect the plug to the power supply.
 To switch on the circular saw, press the lock-off button
(15) and pull the ON/OFF switch trigger (14).
 When you release the switch trigger (14), the tool turns
off.
Parallel cut adjustment
 Loosen the lock knob of edge guide (7).
 Slide the parallel guide (9) through the slots in the shoe to
the desired width.
 Tighten the lock bolt to fit it in the position.
 Ensure that the edge guide rests against the wood along
its entire length to give a consistent parallel cut.