Instructions / Assembly

Adjustments

Spindle speeds

This drill press offers 12 spindle speeds from 300 to 2900 RPM. The highest speed is obtained when the

belt is positioned on the largest motor pulley step and the smallest spindle pulley stop.

WARNING: Disconnect the drill press from the power source before making any speed adjustments.

Table adjustment

1. Raise or lower the Table by loosening the Pivot Lever (1) and

turning the Height Crank (2), clockwise to raise and

counterclockwise to lower.

2. Pivot the Table (3) around the Column by loosening the Pivot

Lever (1). The entire Table assembly and Rack (4), will move as

one around the Column.

3. Tilt the Table by loosening the Angle Bolt (5) and tilting to the

required angle. The angle can be read using the Angle Scale (6).

4. TO ENSURE THAT THE DRILL IS ENTIRELY

PERPENDICULAR TO THE TABLE, insert a straight round bar

(not included) in the Chuck, place a square on the Table (3) and

bring it up to the round bar. Adjust the angle as needed.

CAUTION! To prevent injury from unexpected Table movement,

tighten Angle Bolt (5) and Pivot Lever (1) after adjustment.