Instructions / Assembly

10
Tools needed for assembly
- Adjustable wrench
- Hammer and block of wood
- Screwdriver
Base to column
1. Place Column (1) on the Base (2) and align holes in the
Column with holes in the Base.
2. Attach using Bolt, Spring Washer, and Washer (3) in
each hole through the Column and into the Base.
Table to column
1. Loosen the Pivot Lever (5) on the Table Support (6).
2. Place the Table Support (6) over the Rack (4).
3. Slide the Table Support over the Column (7).
4. Slide the Collar (10) over the Column (7) with the beveled
edge facing down until it presses against the top of the Rack
(4). Tighten the Set Screw (9), but do not overtighten it.
5. Slide the Height Crank (8) over the Shaft on the side of the
Table Support (6). Secure it to the Shaft using the Screw (11)
against the flat part of the Shaft.
1
2
3
4
5
6
7
8
9
10
11