Instructions / Assembly

Remove the chuck at a later time

1. Turn the feed handles to lower the chuck (2) to the lowest position.

2. Place a ball joint separator tool (not included, not shown) above the

chuck (3) and tap it lightly with a hammer (4) to cause the chuck to

drop from the spindle.

Note: To avoid possible damage, be prepared to catch the chuck as it

falls.

Battery Assembly

This drill press is equipped with laser for indicating drilling, and the laser

box is assembled in the factory under the machine head without battery.

When you operate this drill press, please assemble two batteries into the

laser box as the following procedure refer to the picture:

1. Before assemble the batteries, DO NOT adjust the laser lights which

have been adjusted to the best function in the factory.

2. Always use the “AAA” size battery.

3. Please take of the battery cover (3), and use two “AAA” size battery

(2), as the direction in the picture insert them into laser box (1), make

sure

the anode (+) and cathode (-) of battery is according to the marks in battery cover (3).

4. Put battery cover (3) into laser box (1).

5. Please form a habit that always turn off the laser when you do not operate this drill press.

Install the belt

1. Open the pulley and belt cover (1).

2. Loosen the belt tension lock knob (2).

3. Slide the motor (3) as close to the drill press head as possible.

4. Place a belt (4) on the motor pulley (5) and the spindle pulley (6)

in the proper position for the desired speed (see Fig. 10).

5. Pull the motor away from the drill press head until the belt is

properly tensioned. Tighten the belt tension lock knobs.

Note: The belt (4) should be tight enough to prevent slippage. Correct

tension is set if the belt flexes about 1/2" (13 mm) when thumb pressure

is applied at the midpoint of the belt between the pulleys.

3 2 1