Instructions / Assembly

Tools needed for assembly

- Adjustable wrench

- Hammer and block of wood

- Screwdriver

Base to column

1. Place Column (1) on the Base (2) and align holes in the

Column with holes in the Base.

2. Attach using Bolt, Spring Washer, and Washer (2) in

each hole through the Column and into the Base.

Table to column

1. Loosen the Pivot Lever (3) on the table. (2).

2. Slide the Table (2) over the Column (1).

3. Tighten the Pivot Lever (3) to secure the Table (2) in place.

Drill press head to column

1. Lift the drill press head assembly (1) carefully and place

the mounting hole of the drill press head onto the top of

the column (3). Make sure the head is seated properly on

the column.

2. Align the direction of the drill press head to the direction

of the base and the table.

3. Tighten the set screws (2) using the wrench.

4. Thread the three feed handle rods (4) into the holes on the

feed hub.

5. Hand tighten.

Note: One or two of the feed handles may be removed if an

unusually-shaped workpiece interferes with handle rotation.

Install the chuck

1. Inspect and clean the taper hole in the chuck and the spindle. Remove

all grease, coatings, and particles from the chuck and spindle surfaces

with a clean cloth.

2. Open the chuck jaws by turning the chuck barrel clockwise by hand.

Make sure the jaws are completely recessed inside the chuck.

3. Seat the chuck on the spindle by placing a block of wood under the

chuck and tapping the wood with a hammer or tap the chuck with a

rubber mallet.

CAUTION: To avoid damaging the chuck, make sure the jaws are

completely recessed into the chuck. Do not use a metal hammer directly to drive the chuck into the

spindle.