Instructions / Assembly

Accessories

Floor brush is Flat suction nozzle is suit Blowing port is suit for blowing

Suit for the floor, carpet for the crevice corner and out the dust in the crevice of the

and so on. Other places dusting and machine.

sopping up.

Vacuuming Dry

Dust drum’s cleaning.

1. When finish dust suction or there is full of dust inside the drum, it

will cause the suction’s decreased, please turn off the power

supply and clean the rubbish inside drum..

1) Open the clip, take out the machine head.

2) Loose the bottom knob of heap filter anticlockwise, then take

off the heap filter, clean the dust and inside the dust drum.

3) Put the heap filter back to original position. Then install the

machine head. Close the clip.

(Switch should be same towards with vacuum port.)

Vacuuming Liquids

Hepa filter when be used for vacuum water.

1. When finish the cleaning or the container is full of water please power off and pull out the water in

the drum.

1) Open the clip, take out the machine head.

2) Pull out water, and clean & dry the Hepa filter.

3) Connect the Hepa filter same as before. Install the machine head. Close the clip.

(Switch should be same towards with vacuum port.)

IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or

tears in it. Even a small hole can cause a lot of dust to come out of your Vac. If your filter is damaged or

worn, replace it immediately.