INSTRUCTION MANUAL 6 Gallon Portable Wet/Dry Vac Model # PS260 Have product questions or need technical support? Please feel free to contact us! Website: www.Amerisuninc.com Toll free: 1-800-791-9458 M-F 9-5 EST Email: support@amerisuninc.
CONTENTS Technical data…...………………………………………………………... General safety rules…….………………………………………………... Specific safety rules for vacuum……...…………………………………. Knowing your vacuum……...…………………………………………… Assembly and adjustments……………………………………………… Operation………………………………………………………………... Maintenance.…………………………………………………………… Troubleshooting………………………………………………………….
GENERAL SAFETY RULES Safety is a combination of common sense, staying alert, and knowing how your vacuum works. SAVE THESE SAFETY INSTRUCTIONS. WARNING: To avoid mistakes that could cause serious injury, do not plug in vacuum until the following steps have been read and understood. WARNING: This appliance is not intended for use by children or by unassisted, unsupervised persons whose physical, sensory or mental capabilities prevent them from using it safely.
SPECIFIC SAFETY RULES FOR VACUUM WARNING: Do not operate your vacuum until it is completely assembled and installed according to the instructions. 1. PLEASE DO NOT USE the vacuum near some liquids or gases which is inflammable and explosive, in order to avoid the fire. 2. Before plug in and out, please turn off the power, in order to avoid the fire and get an electric shock. 3. PLEASE DO NOT TOUCH the plug when your hands are wet, in order to avoid getting an electric shock. 4.
Guidelines for using extension cords Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table below shows the correct size to be used according to cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.
KNOWING YOUR VACUUM A B C D E K Carrying Handle ON/OFF switch Hose Connector Hose Air Flow Control Outfall F G H I J L 7 Hand Piece Exhaust Port Power Cord Wheels Drum Vacuum Port
ASSEMBLY AND ADJUSTMENTS Unpacking Unpack the vacuum and all its parts, and compare against the list below. Do not discard the carton or any packaging until the vacuum is completely assembled. Please call 1-800-791-91458 or E-mail us at support@amerisuninc.com if any parts are damaged or missing. ACCESSORIES INCLUDED Extension wands Floor brush Round Brush & Crevice Tool Hose Wheel Assembly Insert the four wheel component into the bottom holes of container separately.
WARNING: Read and thoroughly understand all instructions and safety information before operating this vacuum. Failure to do so may cause serious injury or death. Do not allow anyone to operate this vacuum who has not read this manual. As with all power equipment, a vacuum can be dangerous if assembled or used improperly. Do not operate this vacuum if you have doubts or questions concerning safe operation. Call our customer service department at 1-800-791-9458 to address these concerns.
Handpiece connect with brush Contact joint: insert the end of the hose into the brush. OPERATION WARNING: To reduce the risk of fire, explosion, or damage to Vac: • Do not leave Vac running while unattended - you may fail to notice important signs indicating abnormal operation such as loss of suction, debris/liquid exiting exhaust, or abnormal motor noises. Immediately stop using Vac if you notice these signs. • Do not leave Vac plugged-in when not in use.
Accessories Floor brush is Suit for the floor, carpet and so on. Flat suction nozzle is suit for the crevice corner and Other places dusting and sopping up. Blowing port is suit for blowing out the dust in the crevice of the machine. Vacuuming Dry Dust drum’s cleaning. 1. When finish dust suction or there is full of dust inside the drum, it will cause the suction’s decreased, please turn off the power supply and clean the rubbish inside drum.. 1) Open the clip, take out the machine head.
MAINTENANCE Cleaning To keep your Wet/Dry vacuum looking its best, clean the outside with a cloth dampened with warm water and mild soap. To clean the drum: 1. Dump debris out. 2. Wash drum thoroughly with warm water and mild soap. 3. Wipe out with dry cloth. Cleaning A Dry Filter NOTE: For best cleaning results due to accumulated dust, clean the filter in an open area. Cleaning SHOULD be done outdoors and not in the living quarters. Remove filter from Vac.
EXPLODED VIEW & PARTS LIST 13
Item Stock # 1 PS260-001 2 Description Qty 41 PS260-041 Car nozzle 1 Carrying Handle 1 42 PS260-042 Floor brush nozzle 1 PS260-002 Lid assembly 1 43 PS260-043 Extension wands 2 3 PS260-003 Soundproof sponge 1 44 PS260-044 Screw(M4*20) 2 4 PS260-004 ON/OFF Switch 1 45 PS260-045 Screw(M4*20) 2 5 PS260-005 Suction canal 1 46 PS260-046 Screw(M4*16) 4 6 PS260-006 Power cord 1 47 PS260-047 Screw(M4*16) 5 7 PS260-007 Motor 1 48 PS260-048 Screw(M4*16) 2
TWO (2) YEARS LIMITED WARRANTY PowerSmart® is committed to building tools that are dependable for years. Our warranties are consistent with our commitment and dedication to quality. TWO (2) YEARS LIMITED WARRANTY OF POWER SMART PRODUCTS FOR HOME USE. PowerSmart (“Seller") warrants to the original purchaser only, that all PowerSmart consumer power tools will be free from defects in material or workmanship for a period of two (2) years from date of purchase.
