Instructions / Assembly

Floor brush is Flat suction nozzle is suit Blowing port is suit for blowing

Suit for the floor, carpet for the crevice corner and out the dust in the crevice of the

and so on. Other places dusting and machine.

sopping up.

Vacuuming Dry Materials

Add a dust bag when used for dry only, easy to clean.

1. Open the clip, take out the machine head, then connect the

washable dust bag with the vacuum port.

2. When finish the cleaning or suction power is losing

obviously, please power off and pull out the dust from the

dust bag.

1) Open the clip, take out the machine head.

2) Take out the dust bag, and pull out the dust.

3) Connect the dust bag same as before. Install the

machine head. Close the clip.

(Switch should be same towards with vacuum port.)

Vacuuming Liquids

Sponge filter when be used for vacuum water.

1. Open the clip, take out the machine head, and put sponge filter on the bottom basket.

2. When finish the cleaning or the container is full of water please power off and pull out the water in

the drum.

1) Open the clip, take out the machine head.

2) Pull out water, and dry the sponge filter.

3) Connect the sponge filter same as before. Install the machine head. Close the clip.

(Switch should be same towards with vacuum port.)

IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or

tears in it. Even a small hole can cause a lot of dust to come out of your Vac. If your filter is damaged or

worn, replace it immediately.