Instructions / Assembly

9
ASSEMBLY AND ADJUSTMENTS (CONTINUED)
Connect the garden hose to pressure washer
Connect the garden hose adaptor (female coupler) to the water inlet of the
pressure washer, then thread your garden hose (male end) into the garden hose
adaptor. You may need take the male connector of from the quick connector.
The garden hose must have an internal diameter of at least 13 mm (1/2 in.) and
must be reinforced. The water supply must be at least equal to the washer
delivery capacity.
Setup water gun
The pressure washer is equipped with an adjustable Spray wand.
Fit the wand into the gun and rotate it until the two parts are completely locked.
OPERATION
Automatic ON/OFF
The motor on this pressure washer does not run continuously. It only runs when the trigger of the spray
gun is squeezed.
Bleeding the gun
It is very important to bleed the gun before using the pressure washer. Squeeze the trigger to allow any air
that is trapped inside of the unit and hose to escape. Continue to squeeze trigger until a steady stream of
water comes from the nozzle. (This process may take up to 2 minutes).
Using the spray gun
Flip the lock tab behind the trigger up or down until it clicks to apply or remove the safety. Pull back on
the trigger to begin operating pressure washer. To stop water flow, release trigger.
NOTE: The motor only runs when the trigger is operated and shuts off when the trigger is released.