Instructions / Assembly

STARTING THE ENGINE

Before Starting the Engine:

a. Inspect the equipment and engine.

b. Fill the engine with the proper amount and type of both stabilizer-treated unleaded gasoline and oil.

c. Clean debris from discharge area — engine will not start if discharge area is jammed.

d. Engage the Wheel Locks on both wheels to prevent Chipper/Shredder movement during use.

Manual start

1. Turn the fuel cock to the “ON” position (See fig.11).

2. Turn the choke lever to the "START" position.

If the gasoline engine is hot, turn the choke lever to the "RUN"

position (See fig.12).

3. Move throttle handle to left a little (See fig.13).

4. Turn the engine switch to the “ON”(OPEN) position (See fig.14). Pull the starter grip lightly until

resistance is felt,then briskly (See fig.15).

Notice: Don’t allow the starter grip to snap back against the engine. Return it gently to prevent

damage to the starter.

Fig.11

Fig.12

Fig.13

Fig.14

Fig.15