Instructions / Assembly

14
OPERATION
WARNING: Read the entire important safety information section at the beginning of
this manual including all text under subheadings therein before set up or use of this
product.
PRE-START CHECKS
Inspect engine and equipment looking for damaged, loose, and missing parts before set up and
starting. If any problems are found, do not use equipment until fixed properly.
Checking and Filling Engine Oil
NOTICE: Your Warranty is VOID if the engine’s crankcase is not properly filled with oil before each
use. Before each use, check the oil level. Engine will not start with low or no engine oil.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Clean the top of the Dipstick and the area around it. Remove the Dipstick by turning it
counterclockwise, and wipe it off with a clean, lint free rag.
4. The oil capacity of the engine crankcase is 16.9 fl. oz. Reinsert the Dipstick without threading it in
and remove it to check the oil level. The oil level should be up to the full level as shown above.
5. If the oil level is at or below the low mark add the appropriate type of oil until the oil level is at the
proper level. SAE 10W-30 oil is recommended for general use. Other viscosities shown in the
chart may be used when the average temperature in your area is within the indicated range.
6.Thread the dipstick back in clockwise.
NOTICE: Do not run the engine with too little oil. Engine will shut off if engine oil level is too low.
Fig.8
Fig.9