Instructions / Assembly

11
ASSEMBLY AND ADJUSTMENTS (CONTINUED)
Tools needed for assembly
• Adjustable wrench
• Screwdriver
Setup the stand and attach wheels
1. Insert the end frame (20) into each hole of the two legs (19 & 21).
2. Position the axle tube (12) between the two legs (19 & 21).
3. Slide the wheel axle (10) through the hole in one of the legs (19) then through the axle tube
(12) and out through the hole in the other leg (21).
4. Position the washers (14) and wheel spacer (11) on each end of
the axle.
5. Push the wheels (9) onto each end of the wheel axle (10).
6. Position the washers (13) and the locknuts on each end of the wheel axle and tighten both the
wheel nuts using a wrench.
NOTE. The wheels must be fitted the correct way round to allow the nuts to tighten on each end of
the axle.
20
19
21