Product Manual

***Assembling Drive, Auger & Shift Cables over the top of the Frame Handle will
cause unnecessary tension in the cables, resulting in the Snow blower propelling
forward when starting the engine and may cause damage to the drive & auger control
(levers) when trying to engage them.
4. Cut and remove all tie wraps that are on Cables, Frame Handles, Drive Control (Lever) & Auger
Control (Lever).
5. Verify that the connection for the Upper & Lower Drive/Auger Cables is accurate. (See Figure 2)
Figure 2
Step 2: Installing the Chute Assembly
1. Install the discharge chute on the flange of the auger housing chute as illustrated.
2. Attached two bolts in the chute hole and install the mounting bracket as illustrated below.(See Figure
3)
Figure 3
Step 3: Installing the Chute Handle
1. Slide Chute Handle through Chute Handle Guide near the Upper Panel, as indicated on Figure 4.
13