Instructions / Assembly

16
MAINTENANCE
Proper routine maintenance of this mower will help prolong the life of the machine.
Always observe safety rules when performing any maintenance.
The warranty on this lawn mower does not cover items that have been subjected to operator abuse or
negligence. To receive full valve from warranty, operator must maintain the lawn mower as instructed
here.
Changing of engine-governed speed will void engine warranty.
All adjustments should be checked at least once each season.
Periodically check all fasteners and make sure these are tight.
Warning: Always stop engine, allow engine to cool, disconnect spark plug wire before
performing any type of maintenance on your machine.
DECK CARE
It is important to clean underside of the mower deck after use to prevent the build-up of grass clippings or
other debris. Follow steps below for proper cleaning.
1. Move the machine to a level surface.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Lower the machine to its lowest cutting height setting.
Refer to Adjusting the Cutting Height .
4. Attach a hose to the washout fitting, and turn the water
on high.
Note: Spread petroleum jelly on the washout fitting O-ring
to make the coupling slide on easier and protect the O-ring.
5. Start the engine, engage the blade-control lever, and let
the machine run for 1 to 3 minutes.
6. Disengage the blade-control lever, stop the engine, and
wait for all moving parts to stop.
7. Shut off the water and remove the coupling from the
washout fitting.
Note: If the machine is not clean after a single washing, soak it and let it stand for 30 minutes. Then
repeat the process.
8. Run the machine again and engage the blades for 1 to 3 minutes to remove the excess water.
MOWER BLADE