Instructions / Assembly

7
2. Attached the upper handle to the lower handle
using (4) nut,washers and bolts.
NOTICE: Do not bend or kink the control cables.
The cables should be routed under the handle
assembly and not wrapped around the handle or
knobs. The cables must move freely and not bind.
3. Secure the speed control cables to the handle
with provided clips.
Note: Do not secure the auger or drive control
cables with the clips.
2. Hold the discharge chute and handle to align
the mounting holes to chute base mount
holes. Insert the screws and washers and
secure with locknuts. Do not over-tighten the
screws.
NOTICE: Make sure all fasteners are tightened
Chute Assembly
1. Loosen and remove the three sets of screws,
locknuts and washers on the discharge c