Instructions / Assembly

AUGER BELT INSTALLATION

WARNING! Entanglement Hazard – Before performing any service procedures, make sure the engine is

off and remove the spark plug wire from the spark plug to ensure the engine cannot accidently start.

1. Push the auger tension pulley arm to move the auger brake to allow access for installation of the belt

into the auger pulley.

2. Route the belt to the inside of the tension pulley and install the auger belt onto the drive pulley while

pulling the auger housing into position with the main frame.

3. Install and/or tighten the hex nuts attaching the auger housing to the main frame. Tighten all fasteners

securely, do not over tighten.

4. With the belt installed on both pulleys and tension pulley in position, move the belt guide pin to

within 3/16 to 3/8 in. from the belt seated in the pulley and tighten the pin in position.

Note: The belt guide pin helps keep the belt in the pulley when the belt is disengaged. The pin should not

be tight to the belt. The pin should be loose enough to allow the belt to spin freely but not allow the belt to

jump off the pulley.

5. Connect the lower auger cable to the cable adjustment plate.

WARNING! Ensure the belt cover is installed and all safety guards are in place before the engine is

started and at all times when the engine or machine are operating.

6. Install belt cover using 2 hex head screws. Make sure the auger

cable is routed outside the belt cover as shown.

NOTICE: After initial belt installation and adjustment,

re-adjustment of the belt is recommended after a period of

operation. Belt tension should be checked periodically to ensure

proper tension is maintained.

A loose belt will cause:

• Premature belt wear / damage /cracking /fraying

• Belt slipping ("squealing may also be heard")

• No or erratic/slow auger operation – poor performance

A tight belt will cause:

• Premature belt wear / damage / breaking/stretching

• Belt overheat / burning

• Loss of auger engagement control (always engaged)

• Tension pulley damage

• Pulley bearing damage

Step 2 Step 3

Step 5