Use and Care Manual

7
2.
Attach the chute rotation bar to the mount
bracket onto the chute housing using two hex
screws, washers and locknuts. Tighten
fasteners securely.
3.
Slide the
chute crank rod through the
mounting
hole
2. Attached the upper handle to the lower handle
using four (4) knobs, washers and bolts.
NOTICE: Do not bend or kink the control cables.
The cables should be routed under the handle
assembly and not wrapped around the handle or
knobs. The cables must move freely and not bind.
3. Secure the speed control cables to the handle
with provided clips.
Note: Do not secure the auger or drive control
cables with the clips.
Chute Assembly
1. Install the discharge chute onto the chute
flange on the housing. The chute only rests on
the flange.
on the left upper handle.