Use and Care Manual

14
Note: The upper cable end must be in the
upper single center hole of the adjustment
plate. Do not change the position of the upper
cable.
5. Connect the upper cable to the control handle.
6. Start the engine and engage the drive control
handle to test the operation of the drive
engagement.
Note: With the drive control handle at the full
released position, the cable should be barely
tight. Some slack in the cable may be
required to ensure the drive control is not
engaging the drive friction wheel. There
should be no drive movement with the drive
control handle released. If the drive is
engaged when the drive control handle is
released, loosen the cable tension by
readjusting the cable as necessary. Do not
over tension the cable.
Drive Speed Control Cable
Adjustment
WARNING! Entanglement Hazard - Use
caution when performing the speed control
cable adjustment.
Th
e speed control lever is connected to two
cables that work in tandem to control machine
speed and direction. As the speed control lever is
moved from forward to reverse gears (right to
left) one cable is pulled and one is pushed.
Depending on if the cable setting is biased
towards forward or reverse, adjustment of the
cables will vary.
To adjust the cables one cable should be moved
up and the other down equally in their respective
brackets until there is a positive direction change
when the lever is shifted between F1 and R1.
The middle position between these two settings
is neutral (there is no actual neutral "notched"
position on the control panel)
1. With the engine running engage the drive
control handle and move the spee
d control
lever between F1 and R1 to determine which
way the cables need to be adjusted. Release
the drive control handle when shifting between
gears.
2. Loosen the jam nuts on each cable (only one
or two threads) and move each cable up and
down as required until a positive direction
change is achieved when the lever is shifted
between F1 and R1. This may take multiple
attempts to find the exact setting.
3. Tighten the cable jam nuts once the proper
setting has been achieved.
4. Adjustment is made by changing the position
of the lower cable in the adjustment plate
holes (1 to 9). Only move the lower cable
diagonally one hole at a time from its original
position.
4. Lubricate with WD-40 for ease of movement.