Instructions / Assembly

16
TROUBLESHOOTING
Problem
Possible Causes
Remedy
WARNING - Before attempting to make any inspections, repairs or adjustments, stop the snow thrower, wait for
all moving parts to stop moving and carefully disconnect the AC extension cord from the power source.
No start
condition,
won't not
turn on
No power from AC
power source
Connect to known good AC power source
Extension cord not
connected
Securely connect extension cord at power source and
snow thrower
Extension cord faulty
Connect a known good extension cord
Improper starting
procedure
Review "Powering ON and OFF" procedure in this
manual
Auger damaged or
blocked
Check auger for damage, blockage or frozen
condition, repair as required
Faulty switch, wiring or
motor
Call customer service or contact service center
Turns on,
but won't
blow snow
Auger damaged or
blocked
Check auger for damage, blockage or frozen
condition, repair as required
Chute blocked or
damaged
Check chute for damage or blockage, repair as
required
Drive belt damaged
or loose
Check drive belt condition, repair as required (drive
belt is located on left side behind cover)
Turns on,
but won't
run at full
speed
Extension cord faulty
Connect a known good extension cord
Improper extension
cord
Check extension cord length and gauge for use in proper
application, Review "Extension Cord Chart" in this manual
Auger damaged or
blocked
Check auger for damage, blockage or frozen
condition, repair as required
Drive belt damaged or
loose
Check drive belt condition, repair as required (drive
belt is located on left side behind cover)
Faulty wiring or motor
Call customer service or contact service center