Instructions / Assembly

Table Of Contents

6. Locate the three cable clips in the parts bag. Secure the power cord to the frame of the unit by clipping them onto

the frame at evenly spaced intervals.

OPERATING INSTRUCTIONS

Note: Before using this machine, make sure that the power source you will use complies with the

specification’sdetailedinthismanual.Beforeinsertingtheplugintothesocket, verify that the snow throwers auger and

scraper are firmly attached with screws. Perform a test run to ensure that the rotor turns freely.

SECURING THE EXTENSION CORD

1. For safe and efficient use of your snow thrower, use only a UL-rated extension cord recommended for outdoor

use. Refer to the Extension Cord Chart below.

WARNING

Electric shock may cause SEVERE INJURY or DEATH. Heed these warnings:

• Do not allow any part of snow thrower to make contact with water while powered on. If the appliance becomes

wet while turned off, wipe dry before starting.

• Use only a UL-rated extension cord for outdoor, all-weather use. Do not use an extension cord more

than150feet long.

• Don't touch the appliance or its plug with wet hands or while standing in water. Wearing rubber boots offers

some protection.

EXTENTION CORD CHART

Cord Length

Up to 100 ft.

100-150ft.

Wire Gauge

Clip