Use and Care Manual

3. Remove (Qty. 4) hex nuts and remove big bottom plate.

4. Separate the belt from the drive pulley as shown in step 4.

5. Remove the auger belt from bottom as shown in step 5.

AUGER BELT INSTALLATION

WARNING! Entanglement Hazard – Before performing any service procedures, make sure the

battery is off to ensure the machine cannot accidently start.

1. Insert belt and install to the small pulley as shown in step 1.

2. Press the belt on the small pulley as shown in step 2.

3. Install another side belt to big pulley from bottom as shown in step 3. Make sure the belt is

between big pulley and tension plate.

4. Attach the tension spring to the tensioning plate as shown in step 4.

5. Install belt cover and bottom plate.

Step 4 Step 5

Step 1 Step 2

Step 3 Step 4