Use and Care Manual

Unpacking

• Grasp the rear handle and the front part of the product at the same time to carefully lift the tool up

and out of the carton. Remove any other accessories from the carton. Make sure that all items

listed in the packing list are included.

Unpack the snow blower and all its parts and compare against the list below.

1. Snow Blower

2. Discharge Chute Assembly

3. (Qty. 2) one set of Skid Shoes with attaching hardware

4. Two tires with dowel pins.

5. Battery Pack

6. Charger

7. Owner’s Manual

8. Safety Key

ASSEMBLY

Your Snow Blower will require some assembly. Please complete the following steps before using

your Snow Blower.

Step 1: Installing the Tires

1. Installing left and right tire as indicated on Figure 1. Please move left tire to right if axle move to

left when you install right tire.

2. Insert bolt and dowel pin as indicated on Figure 2.

Step 2: Installing the Upper Handle

1. Attach Upper Handle using the Frame Handle Assembly Hardware (4 sets /Knob, Saddle Washer,

M8 Nut, T-Screw) for your Upper & Lower Handle connection. (Fig.3)

2. Tighten Cable as Fig.3.

Fig.1

Fig.2