Use and Care Manual

10
ON/OFF
Located on the left of the panel,the ON/FF button must be pressed down before motor can be started.
Auger Control Trigger
Located on the left side of the handle, the Auger Control Trigger is used to engage and disengage the augers.
Squeeze the Auger Control Trigger to engage the augers; release to disengage the augers.
Drive Control Trigger
Located on the right side of the handle, the Drive Control Trigger is used to engage and disengage the drive
wheels. Squeeze the Drive Control Trigger against the lower handle to engage the wheels; release to disengage.
Drive Speed Control
The Speed Control is located on the right handle and is used to set the drive speed and direction of travel. It can
be moved into any of five positions (four forward and one reverse settings)
Chute Rotation Button
Located on the left side of the handle,push the button,chute should rotate 180 degrees.
Skid Shoe
Position the shoes based on the surface conditions. Adjust upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
Auger Blade and Impeller
When engaged, the auger blades rotate to cut snow and direct it into the auger/impeller housing to be discharged
out the chute.
Clean-out Tool
The chute Clean-out Tool is conveniently fastened to the rear of the auger housing with a mounting clip. It is used
to clean the chute assembly and chute opening when snow and ice become lodged.
WARNING! Never use your hands to clear a clogged chute assembly. Shut off machine and remain behind handles
until all moving parts have stopped before unclogging.
LED Light
Located on the front of the panel,this feature provides extra light for increased visibilityma
ASSEMBLY
The following section describes steps necessary to prepare the snow blower for use. If after reading
this section, you are unsure about how to perform any of the steps please call [phone] Mon-Fri
9-5 EST for customer service assistance. Failure to perform these steps properly can damage the snow
blower.
WARNING: To prevent accidental starting that could cause serious personal injury, always
remove the battery pack from the tool when assembling parts.
WARNING: If any parts are damaged or missing, do not operate this product until the parts are
replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for use
with this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to serious injury.