INSTRUCTION MANUAL EN 21" 2-in-1 GAS PUSH LAWN MOWER ES 21" 2-en-1 CORTADORA DE CÉSPED A GASOLINA Model # DB2321CR Have product questions or need technical support? Please feel free to contact us! Website: www.Amerisuninc.com www.powersmartusa.com Toll free: 1-800-791-9458 Mon-Fri 9-5 EST Email: support@amerisuninc.
EN CONTENTS Technical data…...……………………………………………………….. Introduction………………………………………………………………. Safety information…….………………………………………………... General safety procedures ……....……………………………………… Important safety instructions……………………………………………. Waring label instructions…………………………………..…………… Knowing your lawn mower……………………………………………… Lawn mower preparation………………………………………………... Operation……………………....………………………………………… Maintenance……………………………………………………………... Storage…………………………………………………………………….
INTRODUCTION Thank You for Purchasing a PowerSmart® Product. This manual provides information regarding the safe operation and maintenance of this product. Every effort has been made to ensure the accuracy of the information in this manual. PowerSmart® reserves the right to change this product and specifications at any time without prior notice. Please keep this manual available to all users during the entire life of the lawn mower.
GENERAL SAFETY PROCEDURES For any questions regarding the hazard and safety notices listed in this manual or on the product, please call (800) 791-9458 Mon-Fri 9-5 EST before using the engine. DANGER: CARBON MONOXIDE Using an engine indoors CAN KILL YOU IN MINUTES. Engine exhaust contains carbon monoxide (CO). This is a poison gas you cannot see or smell. If you can smell the engine exhaust, you are breathing CO. But even if you cannot smell the exhaust, you could be breathing CO.
IMPORTANT SAFETY INSTRUCTIONS This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. I.General Operation 1. Read, understand, and follow instructions and warnings in this manual and on the machine, engine and attachments. 2. Only allow operators, who are responsible, trained, familiar with the instructions, and physically capable to operate the machine. 3.
V. SLOPE SPECIFIC Slopes are a major factor related to accidents. Operation on slopes requires extra caution. 1. Travel in the manufacturer recommended direction on slopes. Use caution while operating near drop offs. 2. Avoid mowing wet grass. (Poor footing could cause a slip and fall accident.) 3. Do not operate machine under any condition where traction, steering, or stability is in question. Tires could slide even if the wheels are stopped. 4. Always keep the machine in gear when going down slopes.
WARNING LABLE INSTRUCTIONS Read carefully the manual before use. Danger-flying objects; keep safe distance from the machine as long as the engine is running. Do not open or remove safety shields while engine is running. Pay more attention to the operator’s hands and feet to avoid injury. Do not open or remove safety shields while engine is running. Fuel is flammable,keep fire away. Never fill up the fuel tank while the engine is running.
Look behind while backing Steep slope hazard When mowing,please wear the glasses ad ear plugs to defend the operator himself When repairing, please pull off the spark plug boot, then repair it according to the operational manual Hot surfaces Keep bystanders away. Safety label found on the lawn mower: KEEP HANDS AND FEET AWAY. Warning: Keep the safety signs clear and visible on the equipment.Replace the safety signs if they are missing or illegible.
KNOWING YOUR LAWN MOWER Please use the illustration below to familiarize yourself with the location and function of the components that control of your lawn mower.
LAWN MOWER PREPARATION The following section describes steps necessary to prepare the lawn mower for use. If after reading this section, you are unsure about how to perform any of the steps please call (800)791-9458 Mon-Fri 9-5 EST for customer service. Failure to perform these steps properly can damage the lawn mower or shorten its lifespan. UNPACKING Tools required (not included): #2PH screwdriver, utility knife. Unpack the lawn mower and all its parts, and compare against the list below.
3. Lock the cable to the lower handle using cable clip. Cable Clip 4. Insert the recoil starter handle cable into the hook provided on the upper handle. You must engage the start/stop control to release the recoil starter handle. Start/Stop Control Recoil starter handle SIDE DISCHARGE CHUTE 1. Lift the spring-loaded discharge cover located on the side of the mower. 2. Slide two hooks of the side discharge chute under the hinge pin and lower the spring on the side discharge cover.
ADJUSTING THE CUTTING HEIGHT Warning! Cutting height adjustments should only be performed after the engine and blades have come to a complete stop! It is always best to begin cutting your lawn with a higher deck height to prevent scalping your lawn. The cutting height is adjusted with front and rear levers. Actuate the adjustment lever and pull it to the required position. Please make sure that the lever locks into same position.
Adding Gasoline 1. Remove the fuel tank cap and check fuel level. 2. If the level is too low, refuel the tank, remember adding fuel not over the fuel upper level. Warning: 1. Gasoline is extremely flammable and is explosive under certain conditions. 2. Refueling in a well-ventilation area with the engine stopped. Do not smoke and allow flames or sparks in the area where gasoline is stored or where the fuel tank is refueled. 3. Do not overfill the fuel tank (there should be no fuel in the filling neck).
START THE ENGINE To start the engine, perform the following steps: 1. Check the oil and fuel levels. 2. Press the primer bulb 3 times. 3. Engage the engine Start/Stop Control and simultaneously pull on the recoil starter. Pull on the recoil starter handle slowly until a slight resistance is felt, then pull quickly to start the engine. Return cord gently into the recoil starter. Never allow the cord to snap back. 4. If engine fails to start, repeat step 3.
MAINTENANCE Proper routine maintenance of this mower will help prolong the life of the machine. Always observe safety rules when performing any maintenance. The warranty on this lawn mower does not cover items that have been subjected to operator abuse or negligence. To receive full valve from warranty, operator must maintain the lawn mower as instructed here. Changing of engine-governed speed will void engine warranty. All adjustments should be checked at least once each season.
CHECKING THE OIL The oil capacity of the engine crankcase is 16.9 fl. oz. Check the oil level of the engine according to the Recommended Maintenance Schedule. The lawn mower should be checked before each use for proper oil level. This is a critical step for proper engine starting. To check the oil level: 1. Make sure the lawn mower is on a level surface. 2. Clean around oil fill. Remove dipstick and wipe the dipstick with a clean rag. Insert the dipstick into the oil fill opening without screwing in.
2. Unscrew the spark plug from the engine using the spark plug wrench provided. There is limited space for the wrench to turn. Use both rows of holes in the spark plug wrench to gain leverage to loosen the plug. 3. Visually inspect the spark plug for cracks or excessive electrode wear. Replace as necessary. 4. Measure the plug gap with a wire gauge. The gap should be 0.7 to 0.8 mm (0.028-0.031 in). 5.
3. Remove the spark plug. Use an oil-can to fill the cylinder with approx. 2 ml of oil. Slowly pull back the starter handle, which will bathe the cylinder wall with oil. Screw the spark plug back in. 4. Clean the cooling fins of the cylinder and the housing. 5. Be sure to clean the entire equipment to protect the paint. 6. Store the equipment in a well-ventilated place. NOTE: LIMITED WARRANTY does not cover fuel system damage or engine performance problems resulting from neglected storage preparation.
EXPLODED VIEW AND PARTS LIST 20
Item 1 2 Stock# 303190311 303020241 Description Qty 1 3 Item 26 27 Stock# 303020558 203050500 Side discharge deflector 1 28 303071059 303090066A Spring pin shaft 1 29 303180938A Description Screw M6x35 8 inch Right wheel Rear adjustment spring leaf assembly Rear axle seaming Engine Bolt M8x25 3 203050381 4 5 6 7 8 9 10 303130335 303160456 303020468 203050382A 303010353 203050399B 1 1 2 1 16 1 30 31 32 33 34 35 203050501 303030087 203050401A 303160807 303121005 303010351 8 inch Left w
Engine explode view and part list 22
Qty Item Stock # E01-1 Item 11310-Z3C0110-00A0 Stock # CRANKCASE SUBASSEMBLY. Description 1 E04-3 90408-Z030210-0000 WASHER， FLAT Description Qty 1 E01-2 90682-Z240110-0000 SEAL, OIL 1 E04-4 14200-Z2P0110-00A0 CAMSHAFT ASSY.
THREE (3) YEARS LIMITED WARRANTY PowerSmart is committed to building equipment that will provide years of dependable service. Our warranties are consistent with our commitment and dedication to quality. THREE (3) YEARS LIMITED WARRANTY OF POWER SMART PRODUCTS FOR HOME USE. PowerSmart (“Seller") warrants to the original purchaser only, that all PowerSmart consumer power tools will be free from defects in material or workmanship for a period of three (3) years from date of purchase.
