User Guide

Installation

Failure to follow all installation requirements risks possible death, personal injury,

property damage, and failure of the IntelliStation

Jr. LFIS075VL and LFIS100VL to

perform as intended.

• Installation of these valves MUST be performed by qualiﬁ ed technicians, including licensed electricians

and plumbers, following all manufacturer’s instructions, complying with all local, state, federal and other

governmental requirements, and with all building and construction codes and standards.

• Use ONLY with a potable water distribution system free of debris, foreign materials, corrosive chemicals

or substances, and other adverse conditions.

• LFIS075VL and LFIS100VL are recommended for use as part of an ASSE compliant water distribution

system, including mixing valves and/or temperature limiting devices at all point-of-use ﬁ xtures (faucets,

sinks, tubs, showers, etc.).

• LFIS075VL and LFIS100VL MUST be installed in a dry enclosed area not susceptible to the weather

elements such as rain, snow, ice, freezing temperature, direct sunlight or excessive heat.

• Keep work area clean, well-lighted, free of clutter and distractions, and accessible only by authorized

personnel and workers.

• LFIS075VL and LFIS100VL valves and touchscreen display must be located in accessible and well

lighted area for use, servicing, repair or replacement by authorized personnel.

• Valves Control Module is electrically powered. ALWAYS take proper precautions to recognize, evaluate,

and control electricity hazards during installation, programming, use and service/maintenance.

WARNING

NOTICE

Installation of IntelliStation

Jr. is performed by the owner using qualiﬁ ed and licensed trades such as

plumbers and electricians, following all local, state, federal and other governmental requirements, and all

building and construction codes and standards. Step-by-step installation instructions depend upon the

application and the conﬁ guration of the building’s water distribution system.

All installations require thorough ﬂ ushing of all piping BEFORE installation, and testing for and eliminating all

leaks before and after installation.

Connect inlets and outlet and check for leaks

To connect Power supply

• Press down on top of the front cover and pull out and down

• Lift the front cover up and away from the controller

• Loosen the screws at the front of the wiring cover

• Pull wiring cover straight out from the wiring chamber

• Connect live wire to terminal marked “L” and neutral wire to

terminal marked “N” (see page 8)

• Re-assemble in reverse order.

Front Cover

Wiring Cover