User Manual

TI ES200/ES400 v2 Page 4
Insert the cold water poppet, spring,
and plug into the bottom of the
lower housing.
Carefully insert the bypass assem-
bly into the body.
Install the hot water poppet using
care not to disturb the springs or
bypass assembly.
REASSEMBLY
Lubricate the body “O” ring, and
place in groove on body. Tighten
housing bolts.
Place actuator into motor adaptor
Install bonnet onto valve with 4-
3/16” screws.
Form TI ES200/ES400 v2 0335 EDP # 6508880 Printed in USA
© 2003 Powers, a Watts Industries Co.
USA Phone: [phone] • Fax [phone]
Canada Phone: [phone] • Fax [phone]
www.powerscontrols.com