Technical data

POWX1160 EN
Copyright © 2015 VARO NV P a g e | 6 www.varo.com
8 OPERATION
8.1 Switching ON/OFF
 Switching on: Press the operating switch (8).
 Switching off: Release the operating switch(8)
8.2 Handle attachment (Fig. 3)
For reasons of safety, only use the hammer drill with handle attachment.
You will be able to obtain a safe body position when working by rotating the handle attachment.
Loosen and turn the handle attachment in an ant-clockwise direction. Then tighten the handle
attachment.
8.3 Depth stop (Fig. 4)
Your drilling depth can be pre-set and/or repeated by using the depth gauge (9).
Setting depth: loosen the lock knob for depth stop (7) adequately, slide the depth gauge to
desired depth and securely tighten the lock knob (7) again.
Checking the depth: check the depth with a rule for most accurate measurement and then turn
the adjustment knob to tighten the auxiliary handle in the required position.
8.4 Dust collection device (Fig. 5)
Slide the dust collection device (a) over the drill bit before carrying out any hammer drilling
vertically above your head.
8.5 Hammer / drill switch
 The hammer/drill switch can switch the drill, hammer and hammer/ drill functions.
 There is a lock knob in front hammer/ drill switch, please depressed it first to preventing
any unintentional adjusting.
 To set the function, please use below compounding of front and rear hammer/drill switch.
Hammer/ drill mode:
Drill in masonry, concrete and natural stone.
Don’t use the hammer drill function for ceramic
tile or others material can not withstand impact
energy.
Hammer mode:
Drill in masonry, concrete and natural stone.
Drilling mode:
Drilling in wood, synthetic materials and metal.
WARNING! No function mode:
The motor turns without load,
the shaft will not turn. Do not
set the switch like this. It may
damage the motor greatly.