Technical data

POWX0782 EN
Copyright © 2015 VARO P a g e | 2 www.varo.com
10.1.6 Bevelling (Fig. 10 and Fig. 11)................................................................................ 13
10.1.7 Sawing the workpiece: ........................................................................................... 13
10.1.8 Double mitre cut ..................................................................................................... 14
10.1.9 Sawing the workpiece: ........................................................................................... 14
10.2 Table saw mode ................................................................................................... 14
10.2.1 Safety instructions for the saw blade guard (Fig. 12) .............................................. 14
10.2.2 Riving knife (Fig. 12) .............................................................................................. 14
10.2.3 Lower saw blade guard (Fig. 12) ............................................................................ 14
10.2.4 Push block (Fig. 17 and 18) ................................................................................... 14
10.2.5 Installation.............................................................................................................. 15
10.2.6 Sawing ................................................................................................................... 16
11 CLEANING AND MAINTENANCE ................................................ 16
11.1 Cleaning ............................................................................................................... 16
11.2 Maintenance ......................................................................................................... 16
11.2.1 For all maintenance works ..................................................................................... 16
11.2.2 Before every use .................................................................................................... 16
11.2.3 Monthly (if the saw is used every day) .................................................................... 17
11.2.4 Every 300 operating hours (Fig. 10) ....................................................................... 17
11.2.5 Changing the saw blade (Fig. 19-21) ...................................................................... 17
11.2.6 Tightening the drive belt ......................................................................................... 19
11.2.7 Checking the tension.............................................................................................. 19
11.2.8 Renewed tensioning (Fig. 23-26) ........................................................................... 19
11.2.9 Replacing the saw guide (21) ................................................................................. 19
11.3 Modifications ........................................................................................................ 20
11.3.1 Modifications on the mitre and width guide (Fig. 27) ............................................... 20
11.3.2 Modifications on the mitre scale indicator (Fig. 28) ................................................. 20
11.3.3 Modification of the bevelling angle indicator (Fig. 29) ............................................. 20
11.3.4 Adapting the sawing depth stop (Fig. 30) ............................................................... 20
11.4 Cleaning ............................................................................................................... 20
11.5 Storage ................................................................................................................. 20
12 TECHNICAL DATA ....................................................................... 21
13 NOISE ............................................................................................ 21