Technical data

POWX0782 EN
Copyright © 2015 VARO P a g e | 16 www.varo.com
10.2.6 Sawing
HAZARD! Always use a push block, if the distance D of the workpiece is
less than 120 mm (Fig. 17).
 The front edge of the saw blade guard must rest on the workpiece.
 If necessary, install the mitre and width guide, and make sure that the locking screw points
in the operator's direction.
 Set the mitre and width guide to the desired sawing width. Check on both scales of the
upper saw blade that the mitre and width guide has been set parallel to the saw blade.
 Start the saw blade by pushing the green switch (7) into the “ON” position.
 Push the workpiece slowly towards the back and saw it in one single and flowing
movement.
 If further sawing is not immediately required, then turn the machine off by pushing the red
switch (7) into the “OFF” position.
11 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
11.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
 Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
11.2 Maintenance
 Our machines have been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper machine care
and regular cleaning.
11.2.1 For all maintenance works
 Switch the machine “OFF”
 Remove the plug from the socket
 Wait until the machine has come to a complete standstill
 Repair and maintenance works may only be carried out by trained specialists, with the
exception of those described in this chapter.
 Replace defective parts, especially defective safety facilities. Parts that have not been
tested and approved by the manufacturer can lead to unforeseen damages.
- Make sure that all safety facilities are operational once more, after the completion of
maintenance works.
11.2.2 Before every use
 Remove sawdust and wood splinters from the machine with a brush and dust cloth, or with
a vacuum cleaner.