Technical data

POWX0782 EN
Copyright © 2015 VARO P a g e | 15 www.varo.com
 Replace the push block when damaged.
10.2.5 Installation
HAZARD!
Before starting with the installation of the machine:
- Switch the machine “OFF”
- Remove the plug from the socket
- Wait until at the machine has come to a complete standstill
 Leave the saw head in a raised position.
 Set the mitre saw in the 0° position and tighten up the locking screw.
 You must position the lower saw blade guard correctly and you must make sure that
switch B (29) is activated.
 Lower the saw head and lock it in position.
 Remove the mitre and width guide (4) from the saw blade guard.
HAZARD!
 Before starting to work, check that the following items are in a proper condition.
- Riving knife
- Safety saw blade guard
- Saw blade guard
- Push block
 Wear protective clothing and apply the necessary protective measures:
- Dust exhauster
- Ear protection
- Safety goggles
 Stand in the correct position for operating the machine
- At the front of the saw
- In front of the saw
- At the left side of the sawing line
- If two persons are working at the same time, then the other person must stand at a sufficient
distance from the saw.
 Use following accessories, if required by the type of work you are doing:
- Workpiece support for long workpieces, which would otherwise fall off the table at the end of
the sawing process.
- Dust collector
 Always hold the workpiece against the saw blade and do not block it.
 Do not try to stop the turning of the saw blade, by pressing the workpiece against the side
of the saw blade. A risk of injuries can occur, if the saw blade is blocked.