Technical data

POWX0782 EN
Copyright © 2015 VARO P a g e | 12 www.varo.com
Before starting with the installation of the machine:
- Switch the machine “OFF”
- Remove the plug from the socket
- Wait until at the machine has come to a complete standstill
 The mitre and width guide (4) must be installed, so that the saw blade can be covered and
safely fastened. The mitre and width guide must activate switch A (8); secure the position
with the mitre guide locking knob (5).
 Release the locking knob (22) and lift up the saw head completely
 Remove the lower saw blade guard (14).
 Use the switch (20) for activating the machine.
HAZARD!
 Before using the machine, always check that the following items function properly.
- Movable saw blade guard.
 Wear protective clothing
 Stand in the correct position for operating the machine
- At the front of the saw
- In front of the saw
- To the side of the sawing line
 Crushing hazard! Whenever you tip the sawing head to the side, you must have a firm grip
on the handle of the saw head, keep your fingers away from the support arm and out of
the tilting range! Hold the saw head firmly.
 If required by the type of work you are doing, you must use the following accessories:
- Workpiece support for long workpieces, which would otherwise fall off the table at the end of
the sawing process.
- Dust collector
 Use an additional guide, if small pieces have to be sawn.
 Always hold of the workpiece firmly on the table and do not block it.
 Do not try to stop the turning of the saw blade, by pressing the workpiece against the edge
of the saw blade. A risk of injuries can occur, if the saw blade is blocked.
10.1.4 Normal cross-cut operations
 Starting position:
- Saw head completely raised.
- Turntable in the 0° position; the locking screw of the turntable is tightened.
- The motor head stands in a vertical position (90°), and the bevelling lock knob is tightened.
 Sawing the workpiece:
 Hold the workpiece against the mitre and width guide; if possible use a work clamp (25) for
fastening down the workpiece.
 Activate the switch (20) and activate/push on the safety lock (6).
 Lower the saw head carefully and completely downwards while gripping the handgrip. To
prevent that the speed of the motor slows down, you should only apply medium pressure
while sawing.
 Saw the workpiece in one single movement.
 Carefully let the saw head return to its topmost starting position.