Technical data

POWX0400 EN
Copyright © 2014 VARO NV P a g e | 5 www.varo.com
 Place a new sanding paper on the sanding plate and fasten one clamp first. Press the sand
paper against the sanding plate, bend the other end and fasten the second clamp.
7.4 Fitting dust collection box
 Pull and slide dust collection box over the dust extraction port
 There are release buttons on the sides of the rear cover. Using your fingers, press the
release button in and pull the rear cover off.
8 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
8.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9 TECHNICAL DATA
Voltage
230-240 V AC / 50 Hz
Power input
220 W
Sanding area
187 x 90 mm
No. Of vibrations
12000 min-1
Weight
1.5 kg
Protection class
10 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
86 dB(A)
Acoustic power level LwA
97 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration)
Max 10,4 m/s²
K = 1.5 m/s²
11 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).