Technical data

POWX027 EN

Always use ear-protection, when machine is in use!

Recommended nominal operating-time: approx. 20 minutes under

permanent load.

Rest after permanent operation: approx. 5-10 minutes.

7 OPERATION

WARNING: Prior to assembly and adjustment always pull out the power

plug from the mains socket.

7.1 Switching on/off (Fig. 1)

 Plug the cord set into power socket.

 To start the tool by squeezing the ON/OFF switch (4).

 Release the ON/OFF switch to stop the tool.

 If you press the lock-on button (6) while the ON/OFF switch is depressed, the ON/OFF

switch is kept in the operating position.

 To release the ON/OFF switch (4) and turn the tool off.

7.2 Forward/reverse lever (Fig. 2)

 The forward/reverse lever (3) is to determine the rotation direction of the chuck.

 To select forward rotation, release the ON/OFF switch (4) and push the forward/reverse

lever to right (R) side of the tool. To select reverse rotation, push the lever to left (L) side

of the tool.

NOTE: When changing the position of the lever, be sure the ON/OFF switch

is released and the motor is stationary.

7.3 Variable speed (Fig. 3)

This tool has a speed control dial (5) that delivers higher speed by turning to the “+” direction,

and delivers lower speed by turning to “-”direction.

7.4 Drill and impact mode selector (Fig. 4)

The drill and impact mode selector is on the top of this impact drill.

 Push the button of drill /impact mode selector (2) to the “ ” to select the drill/impact mode

of action.

 Push the button of drill/impact mode selector to the drill position “ ” to select the drill mode

of action.

The drill and impact mode selector is on the top of this impact drill.

7.5 For Proper Operations