Operation Manual

POWLI025 EN

PORTABLE HALOGEN FLOODLIGHT 500W

POWLI025

1 DOMAIN OF USAGE

Outdoor or indoor usage such as jobsite, garden, studio and workshop.

WARNING! Read this manual and general safety instructions

carefully before using the appliance, for your own safety. Your

power tool should only be passed on together with these

instructions.

2 SYMBOLS

In this manual and/or on the machine the following symbols are used:

Read the manual before using the machine

In accordance with essential applicable safety standards of European

directives

3 WARNING

 Never attempt to change wire connection way as this has been fixed professionally.

 The lighting fixture shall be fixed on stand vertically that the longitudinal axis does not

slant than ±4°from the ground plate.

 Disconnect the plug (all-poles) from the network when the front glass is open, and

follow the instructions to the next step

 Do not put the lamp any closer than 1 m to any object.

 Replace before using the shielding glass if it is damaged.

 If the external flexible cable or cord of this luminary is damaged, it shall be

exclusively replaced by the manufacturer or his service agent or a similar qualified

person in order to avoid a hazard.

4 ASSEMBLING LAMP ON TRIPOD

 First loosen the wing-nut screw on the tripod (E) and flex the tripod legs. Make sure

the tripod stands stable and retighten the wing-nut.

 Now twist pole screws(D) left to open and extend to your required height. twist right

to lock the pole so it doesn’t slide down.

 Unscrew the middle wing-nut screw(C) and set up the lamp on the top of the pole.

Lock the lamp with the wing-nut through the central hole of the support frame onto

the tripod. Twist it tightly.

PAGE 1
POWLI025 EN PORTABLE HALOGEN FLOODLIGHT 500W POWLI025 1 DOMAIN OF USAGE Outdoor or indoor usage such as jobsite, garden, studio and workshop. WARNING! Read this manual and general safety instructions carefully before using the appliance, for your own safety. Your power tool should only be passed on together with these instructions.
PAGE 2
POWLI025 EN 5 USING THE FLOODLIGHT  Simply plug in the cable (E) of the floodlight to the socket. 6 FIXING AND CHANGING A HALOGEN TUBE     Switch off lamp before installing the bulb. Remove screw (A) on top of the lamp and open the cover. Push the bulb (B) in between the two prongs. Make sure the prongs are centered on the metal tips of the bulb, not the ceramic casing. To avoid premature burn out of the halogen bulb, It is essential to avoid contact with bare fingers.