Operation Manual

POWE20010 EN

 Fit the desired disc (8) on the spindle and replace the outer flange and backing flange.

Release the spindle lock.

Important! Only ever press the spindle lock when the motor and grinding

spindle are at a standstill!

You must keep the spindle lock pressed while you change the wheel !

For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing

the grinding wheel.

7.4 Special attention when starting the machine

 Clamp the workpiece and make sure that the workpiece cannot slide from under the

machine during the cutting activities.

 When working with the machine, always hold it firmly with both hands and provide for a

secure stance.

 Always direct the cable to the rear away from the machine.

 Insert the mains plug only when the machine is switched off.

 Apply the machine to the workpiece only when switched on

Never use the machine for grinding magnesium workpieces.

7.4.1 Switching On

 Connect the plug to the power supply. The power-on indicator (9) is illumed until the tool

disconnect from the power mains.

 Press the end of the ON/OFF switch down then slide it forwards until it locks.

 The machine will start.

7.4.2 Switching Off

 Unlock the ON/OFF switch, the machine will be switched OFF. The disc will gradually

slow down and eventually stop after a few seconds.

Do not put the machine down when the disc is still turning.

In case of interruption of the mains supply the on/off switch of the tool

needs to be released and reactuated.

8 OPERATON MODES

8.1 Grinding

Hold the handle (3) and auxiliary handle (6) firmly and

switch on. Avoid blocking the ventilation slots with your

hand, as this may cause the grinder to overheat. Let the

disc reach full speed. Apply the grinder to the item.

Maximum effect is achieved when the grinder is held at

an angle of 15-30°in relation to the item. Move the

grinder gently along the item. Give the grinder time to

work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks

can occur in the motor compartment during use. This is normal and does not mean the grinder

is defective. Switch off the grinder after use.