Operation Manual

POWC4010 EN
Copyright © 2017 VARO P a g e | 5 www.varo.com
7 OPERATION
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ..).
7.1 Switching on/off
 To switch on the machine press the on/off switch.
 To switch off the machine, release the on/off switch.
 To switch the machine to continuous mode, you keep the on/off switch fully pressed and
simultaneously press the loch button. And subsequently release the on/off switch.
 To switch off continuous mode, press the on/off switch again.
7.2 Attaching the sandpaper
 Open the paper clamps.
 Take sanding paper of the required grain size and place it on the sanding pad.
 Make sure that the perforation in the paper corresponds with those on the sanding pad.
 Fold tha sanding paper at both ends around the edges of the sanding pad.
 Close the paper clamps one by one.
 Make sure that the ends of the sanding paper are clamped.
 The sanding paper must be fitted firmly on the sanding pad and should not come loose.
7.3 Collecting the dust
 For a better dust extraction of the working surface, your sanding machine can be
connected to the ordinary vacuum cleaner for house-use.
 Slide the suction mouth of a vacuum cleaner onto the connection.
 The vacuum-cleaner connecting piece is supplied with the appliance.
8 TECHNICAL DATA
Power rating
135W
Mains voltage
230-240V
Frequency
50Hz
Sanding surface
90 X 187 mm
No load speed
14000 min
-1
9 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
84 dB(A)
Acoustic power level LwA
95 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration):
3.95 m/s²
K = 1.5 m/s²
10 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.