Operation Manual

POW637… EN

8.1 Adjusting the cutting height of POW63715

Make sure your machine is switched off and the blade has come to a

complete standstill before adjusting the cutting height.

ATTENTION: The blades continue to rotate for a few seconds after the

machine is switched off, a rotating blade can cause injury.

Your lawnmower POW63715 is equipped with a central height adjustment system, offering 6

height settings: 20mm, 30mm, 40mm, 50mm, 60mm and 70mm.

Select the cutting height by locking the lever in the desired position. (Move lever outward, slide

to correct position, move inward to lock it again)

From rear to front, the adjustable height is from 20mm to 70mm.

Note: For the first cut of the season, a high cutting position should be

selected.

9 OPERATION

9.1 Connect to power supply.

Before you connect the equipment to the

mains supply make sure that the data on the

rating plate are identical to the mains data.

Connect the plug to an extension cable. It is

imperative to secure the extension cable with

the cable grip as shown in Figure 5a.

9.2 Starting

Press and hold safety button (then squeeze the switch lever towards the handle). Release the

safety button.