Operation Manual

POW637… EN

When you fit the top push bar you can decide the

height of the push bar by selecting the appropriate

fastening hole (Fig. 3c). Fasten the top push bar

using either the holes L for a low position or H for

a high position.

Screw the top push bar to the bottom push bar as

shown in Fig. 3d.

8 SETTING THE CUTTING HEIGHTS

Important! Adjust the cutting height only when the engine is switched off

and the power cable has been disconnected.

Before you begin to mow, check to ensure that the blade is not blunt and that none of the

fasteners are damaged. To prevent any imbalance, replace blunt and/or damaged blades. To

carry out this check, first switch off the motor and pull out the power plug.

For POW63705：The cutting height is adjusted by turning the hub cap anticlockwise to

release the axle and removing the hub cap with the screw and tire. The tires can now be fitted

in position 1, 2 or 3 to suit the required cutting height. Fit all four tires at the same height so

that the cutting blade runs parallel to the lawn.

Position Cutting depth

1 20mm

2 40mm

3 60mm

For POW63707 and POW63710：The cutting height is adjusted by “spring and bar” system.

The cutting height is adjusted as shown in the figures. To do so, turn the equipment upside

down or tilt it to the side. Position both the front and rear axle in the same notch, so that the

cutting blade runs parallel to the lawn.