Operation Manual

POW637… EN
Copyright © 2010 VARO Page | 11 www.varo.com
9.6 Grass bag
Important! Before you remove the grass bag switch off the motor and wait
until the cutting tool reaches a standstill.
To remove the grass bag, raise the discharge flap with one hand and remove the grass bag
using its handle with your other hand.
To maintain safety, the discharge flap will close when you remove the grass bag to seal the
rear discharge opening. If any grass residues are caught in the opening, it is a good idea to
pull the mower backwards around 1 m to make it easier to start the motor.
Do not remove grass cuttings in the mower casing or on the cutter by hand or with your feet.
Instead use suitable tools such as a brush or broom. To ensure that it can collect the grass
correctly the grass bag and in particular the net must be cleaned from the inside after use.
Only attach the grass bag after switching off the motor and the cutting blade has reached a
standstill.
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull out the power
plug.
10.1 Cleaning
§ Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
§ We recommend that you clean the device immediately each time you have finished using
it.
§ Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no
water can seep into the device.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.