Operation Manual

POW63655

− after striking a foreign object. Inspect the appliance for damage and make repairs as

necessary.

− if the appliance Starts to vibrate abnormally (check immediately).

4 ASSEMBLY

Some parts of the lawnmower have been dismantled for transport purpose. The screws,

wheels, handwheels, cable clips and screwdrivers are to be found in plastic bags. Assembly is

simple if you follow these instructions:

4.1 Grass box

 Put the textile bag and steel frame together (Fig. 2)

4.2 Handle

 Remove the lawnmower from the packaging and connect the deck and the connecting

pipes with screws provided in place.

 Slide the hook for the extension cable onto the lower handle pipe

 Assemble the lower handle pipe to the lawnmower with supplied bolts and nuts as shown

in fig 4

 Insert the nuts in the plastic hand wheels supplied (Fig. 3).

 Attach the handle pipe to the connecting pipe using the round-headed screws supplied

(Fig. 5).

 Fasten the cable leading from the switch -plug combination to the motor along the

connecting pipes using the cable clips supplied (Fig. 1).

4.3 Fitting the logo plate

 Fit the logo plate (13) by putting it on the handle pipe (9) (Fig. 5).

4.4 Assembly of wheels and adjusting the cutting height

 Assembly 4 wheels into 4 supporters in deck. Don't forget to put the necessary grommet

into the supporter of wheel before assembly of wheel (Fig. 3).

 Adjusting the cutting height

− The cutting height is adjusted directly at the four wheels using the height setting handles.

− Six different cutting height settings are available for each individual wheel. All the wheels

have to be adjusted to the same height for mowing.

4.5 Starting the lawnmower

 Before you start mowing, make sure the cutting tools and their fasteners are neither blunt

nor damaged in any way. If necessary, replace any blunt or damaged cutters. Pull out the

power plug before checking.

 To prevent the lawnmower being started inadvertently, the switch -plug combination is

fitted with a safety pressure switch (Fig. 6 No.A) which must be depressed before the

switch lever (Fig. No.B) can be pulled. When the switch lever is released, the safety

pressure switch has to return to its starting position.

 Make sure the extension cable is not within range of the lawnmower blade. Depress the

safety pressure switch and pull the switch lever (Fig. 6).

 Before you start mowing, practice this operation a few times to ensure that everything

functions properly.

 Before carrying out any adjustments or repairing work on your lawnmower, wait until the

blade stops rotating.

 Always disconnect the power plug before carrying out any adjustment, maintenance and

repair work.