Operation Manual

POW3065.. EN

9 CLEANING AND MAINTENANCE

9.1 Cleaning

§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.

§ Regularly clean the machine housing with a soft cloth, preferably after each use.

§ Keep the ventilation slots free from dust and dirt.

§ If the dirt does not come off use a soft cloth moistened with soapy water.

Never use solvents such as petrol, alcohol, ammonia water, etc. These

solvents may damage the plastic parts.

10 TECHNICAL DATA

POW30650

POW30650/2

POW306532

POW306552

Voltage / frequency charging unit 230 V / 50 Hz

Rated Voltage 14.4 V 18 V 18 V

Rotation speed 1

gear 0-350 rpm

Rotation speed 2

gear 0-1250 rpm

Torque positions 24

Max. drill capacity 10 mm

Charger time 3/5 hours 1 hour

Battery capacity 1300 mAh

Battery type Ni-CD

Max. torque 15 Nm

Drill capacity concrete /

Drill capacity steel 10 mm

Drill capacity wood 20 mm

Chuck type Sanou keyless chuck

Number of speed settings 2

11 SOUND EMISSION

Noise emission values measured according to relevant standard.

Acoustic pressure level LpA

dB (A)

K = 3 dB(A)

Acoustic power level LwA 85 dB (A) K = 3 dB(A)

ATTENTION! The sound power pressure may exceed 85 dB(A), in this case

individual hearing protection must be worn.

aw (Vibration) 6.5 m/s² K = 1.5 m/s²

12 SERVICE DEPARTMENT

§ Damaged switches must be replaced by our after-sales service department.

§ If the connecting cable (or mains plug) is damaged, it must be replaced by a particular

connecting cable which is available from our service department. Replacement of the

connecting cable must only be carried out by our service department (see last page) or by

a qualified person (qualified electrician).