Operation Manual

Step2
Insertthebracketonfrontstabilizer(2)intothefrontsupport(29).Unfoldthefrontupright(3)ontothe
frontsupport(29),thenboltthefrontsupport(29),frontupright(3)andfrontstabilizer(2)together
withbolts(M8x15mm)(14)andwashers(M8)(16).Pleasedonottightenanyoftheseboltsuntilallsix
boltsareattached.



Step3
Insertthepedalshaft(5)throughholeslocatedonthefrontupright(3).Placeapedal(4)ontoeachend
ofthepedalshaft(5)andslidethemtowardthefrontupright(3).Thensecurethepedals(4)withbolts
(M8x15mm)(14)andlargewashers(M8)(15)atbothendsofthepedalshaft(5).
Note:youneedtousetwoallenwrenchestotightenthebolts(M8x15mm)(14)atbothendsofthe
pedalshaft(5)atthesametime.






22