Instruction Manual

 Lift the Lid Handle and remove the Lid.
 Add water to reach about 80% the height of the pot.
 Again holding the Lid Handle, lower the Lid back into position.
 Attach the power cable to the appliance and then plug the power cable
into the electric mains and switch on.
 Press the Selector button downwards. The ‘cook’ Indicator light will
illuminate and heating commences.
 Once the water begins to boil, switch off the appliance, unplug the power
cable from the electric mains, followed by the power cable from the
appliance. Wait for the water to cool after boiling. Discard the water.
Then the appliance is safe to use.
d. (Subsequent uses)
 Measure the desired amount of rice with the measuring cup supplied and
place the rice in a clean container (NOT the Inner Pot!) and rinse the rice
with water. Then place the rinsed rice into the Inner Pot and add water.
Level the rice inside the Inner Pot, wipe the exterior of the pot dry and
place the Inner Pot onto the Outer Pot.
 Holding the Lid Handle, lower the Lid back into position.
 Attach the power cable to the appliance and then plug the power cable
into the electric mains and switch on.
 Press the Selector button downwards. The ‘cook’ Indicator light will
illuminate and heating commences.
 When the rice is cooked, the Selector will “pop” up and a “click” sound
will be heard. Simultaneously, the ‘cook’ Indicator light will be replaced
by the ‘warm’ Indicator light. Lift the Lid Handle and scoop the rice out
after 15 minutes.
Make sure to remove any label or protective sheet which may prevent its proper
functioning.
DO NOT:
 cover the appliance during functioning;
 obstruct totally nor partially the Lid;
 insert objects or body parts inside the protection cover of the appliance;
 add water in excess of the “MAX” mark indicated;
 maintain the rice for more than 12 hours in the appliance, even in the ‘warm’
mode as bacteria may start to multiply and the rice will also lose its flavor;
 switch the appliance on if the pot is dry - however, should the Inner Pot be
found empty during operation, immediately unplug the power cable and add
water to avoid dry-boil;
 heat the Inner Pot by any other means, e.g. heating directly on a gas stove, as
the pot can be deformed as a result;