User Manual

resistant surface. Damage to the appliance may occur if it is placed on an
incline or decline.
c. (First use)
 Fill about 80% of the Inner Pot with water and place it into the body on
top of the Heating Plate.
 Holding the Lid Handle, place the Glass Lid onto the Inner Pot securely.
 Switch the appliance ON
Turn the Control Knob anti-clockwise to ‘OFF’. Attach the power
cable to the appliance and then plug the power cable into the
electric mains and switch on. Turn the Control Knob clockwise to
‘Low’, ‘Medium’ or ‘High’, depending on the situation. The Power
Indicator Light will illuminate and heating will commence.
(henceforth “switching the appliance on” is intended to include the steps
above)
 Once the water begins to boil, allow the water to boil for at least 5
minutes.
 Switch the appliance OFF
Turn the Control Knob anti-clockwise to ‘OFF’, switch off the
electric mains, unplug the power cable from the electric mains,
followed by the power cable from the appliance. The Power
Indicator light will turn off, and the heating will cease.
(henceforth “switching the appliance off” is intended to include the steps
above)
 Discard the water and rinse the Inner Pot and Glass Lid under running
water (be very careful NOT to allow water to seep into any openings).
The appliance is then safe to use.
Make sure to remove any label or protective sheet which may prevent its proper
functioning.
DO NOT:
 cover the appliance during functioning;
 obstruct totally nor partially the Glass Lid;
 insert objects or body parts inside the protection cover of the appliance;
 overfill water (beyond the “FULL” mark on the container) to avoid overflow of
hot water;
 switch the appliance on if the Inner Pot is dry - however, should the pot be
found empty during operation, immediately switch off the appliance and add
water to avoid dry-boil;
 heat the Inner Pot by any other means, e.g. heating directly on a gas stove, as
the pot can be deformed as a result;
 leave the appliance unsupervised during operation.