Instruction Manual

How to use s
1. Clean the Motor unit and accessories before using. Refer to the section “How to
clean and maintain” immediately following this section.
2. Place the Motor unit on a flat, dry and heat-resistant surface. Insert the Rotor
into the Plastic Cup.
3. Before adding ingredients, make sure the blades are in place and are running
smoothly.
4. Add food or liquids into the Plastic Cup, not exceeding three-quarters of the
maximum capacity of the 350 ml Plastic Cup.
DO NOT overload the Cup, otherwise the blades may not rotate when the
appliance is switched ON. If this occurs, remove some of the food ingredients.
Food
Weight
(g)
Operating time(s)
Remarks
Meat
(Beef / Pork)
< 300
30
First cut meat to less than
2 x 2 x 3 cm
Remove bones, skin &
tendons before mincing
Garlic
100
15
Chili
100
15
Carrot
100
30
Cut carrot to less than
2 x 2 x 3 cm
Celery
100
15
Add sufficient amount of
liquids before chopping
Sweet Potato
50
< 30
Cooked Carrot
50
< 30
Soft Fruit
100
< 30
5. Attach the Cup Cover onto the Plastic Cup. Make sure that the Rotor is aligned
with the Rotor Holder at the top of the Cup Cover. Install the Plastic Cup onto the
Motor unit. Check that the Motor unit is securely fitted to the Plastic Cup and the
Rotor, through the driving connector, before you start using the appliance.