Instruction Manual

HOW TO CLEAN
1.
2.
3.
4.
5.
6.
7.
Press the Control Button on the Control Panel or the ON/OFF Button on the Remote
Control to switch off the fan.
Unplug the power cable holding it firmly with dry hands.
Wait for the appliance to cool down completely.
Clean the exterior parts of the fan thoroughly with damp cloth moistened with
warm water & detergent with a non-abrasive sponge.
DO NOT use metal scouring pads.
DO NOT use any of the following agents as a cleaner: gasoline, thinners, or benzene.
Never run water over the appliance as malfunctions may occur if water seeps inside
the appliance. Take special care that the Control Panel found at the top of the fan is
kept dry and prevent water from leaking into it.
You may also use a vacuum cleaner to suck up dirt from the Air Inlet.
Pull out the Water Tank at the bottom and back of the appliance.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
Pull out the Drain Valve and wait until all water has flowed out of the Water Tank.
Unlock the Water Pump.
Pull out the Water Pump.
Remove the Water Tank from the appliance completely.
Clean the Water Tank with damp cloth moistened with warm water & detergent
with a non-abrasive sponge. DO NOT use metal scouring pads.
Push the Water Tank back into the appliance.
Put the Water Pump back into the Water Tank.
Lock the Water Pump.
Put the Drain Valve back in.
Use a hose or the Water Container provided (or any clean container) to fill up the
Water Tank with water until the orange water level indicator reaches the top of
the Water Level scale (above the minimum and below the maximum levels of the
tank).
Push the Water Tank into the appliance fully and close the hatch.
7